Configuring Master 810
If you are using Master 810 with an encoder that runs at a quadrature frequency higher than 300 kHz, you must use the device's divider DIP switches to limit the incoming frequency to 300 kHz.
Master 810 supports up to a maximum incoming encoder quadrature frequency of 6.5 MHz. |
The DIP switches are located on the rear of the device.
Switches 5 to 8 are reserved for future use. |
This section describes how to set the DIP switches on Master 810 to do the following:
- Set the divider so that the quadrature frequency of the connected encoder is compatible with the Master.
- Set the debounce period to accommodate faster encoders.
Setting the Divider
To set the divider, you use switches 1 to 3. To determine which divider to use, use the following formula:
Output Quadrature Frequency = Input Quadrature Frequency / Divider
In the formula, use the quadrature frequency of the encoder (for more information, see Encoder Quadrature Frequency) and a divider from the following table so that the Output Quadrature Frequency is no more than 300 kHz.
Divider |
Switch 1 |
Switch 2 |
Switch 3 |
---|---|---|---|
1 |
OFF |
OFF |
OFF |
2 |
ON |
OFF |
OFF |
4 |
OFF |
ON |
OFF |
8 |
ON |
ON |
OFF |
16 |
OFF |
OFF |
ON |
32 |
ON |
OFF |
ON |
64 |
OFF |
ON |
ON |
128 |
ON |
ON |
ON |
The divider works on debounced encoder signals. For more information, see Setting the Debounce Period. |
Encoder Quadrature Frequency
Encoder quadrature frequency is defined as illustrated in the following diagram. It is the frequency of encoder ticks. This may also be referred as the native encoder rate.
You must use a quadrature frequency when determining which divider to use (see Setting the Divider). Consult the datasheet of the encoder you are using to determine its quadrature frequency.
Some encoders may be specified in terms of encoder signal frequency (or period). In this case, convert the signal frequency to quadrature frequency by multiplying the signal frequency by 4. |
Setting the Debounce Period
If the quadrature frequency of the encoder you are using is greater than 3 MHz, you must set the debounce period to “short.” Otherwise, set the debounce period to “long.”
You use switch 4 to set the debounce period.
Debounce period |
Switch 4 |
---|---|
short debounce |
ON |
long debounce |
OFF |