Get Address
The Get Address command is used to discover sensors across subnets.
Field |
Type |
Offset |
Description |
---|---|---|---|
length | 64s | 0 | Command length. |
type | 64s | 8 | Command type (0x1). |
signature | 64s | 16 | Message signature (0x0000504455494D4C) |
deviceId | 64s | 24 | Serial number of the device whose address information is queried. 0 selects all devices. |
Field |
Type |
Offset |
Description |
---|---|---|---|
length | 64s | 0 | Reply length. |
type | 64s | 8 | Reply type (0x1001). |
status | 64s | 16 | Operation status. |
signature | 64s | 24 | Message signature (0x0000504455494D4C) |
deviceId | 64s | 32 | Serial number. |
dhcpEnabled | 64s | 40 | 0 – Disabled 1 – Enabled |
reserved[4] | byte | 48 | Reserved. |
address[4] | byte | 52 | The IP address in left to right order. |
reserved[4] | byte | 56 | Reserved. |
subnetMask[4] | byte | 60 | The subnet mask in left to right order. |
reserved[4] | byte | 64 | Reserved. |
gateway[4] | byte | 68 | The gateway address in left to right order. |
reserved[4] | byte | 72 | Reserved. |
reserved[4] | byte | 76 | Reserved. |