Start Upgrade
The Start Upgrade command begins a firmware upgrade for the sensors in a system. All sensors automatically reset 3 seconds after the upgrade process is complete.
|
Field |
Type |
Offset |
Description |
|---|---|---|---|
|
length |
64s |
0 |
Command size including this field, in bytes. |
|
id |
64s |
8 |
Command identifier (0x0000). |
|
length |
64s |
16 |
Length of the upgrade package (bytes). |
|
data[length] |
byte |
24 |
Upgrade package data. |
|
Field |
Type |
Offset |
Description |
|---|---|---|---|
|
length |
64s |
0 |
Reply size including this field, in bytes. |
|
id |
64s |
8 |
Reply identifier (0x0000). |
|
status |
64s |
16 |
Reply status. For a list of status codes, see Status Codes. |